Home Improvement Thread
Home Improvement Thread
2020 part II: The Sequel began yesterday. Had to replace the hot water heater - looks like the stimulus check will come in handy!
-
- Posts: 61152
- Joined: Sun Oct 04, 2015 2:00 pm
- Location: FUCΚ! Even in the future nothing works.
Home Improvement Thread
You're like the third one of us in the last year who had to replace their water heater. Welcome to the New Water Heater Club!2020 part II: The Sequel began yesterday. Had to replace the hot water heater - looks like the stimulus check will come in handy!
Home Improvement Thread
It was definitely time. The old one was installed in '98, and it took a while for most of the taps to get hot.You're like the third one of us in the last year who had to replace their water heater. Welcome to the New Water Heater Club!2020 part II: The Sequel began yesterday. Had to replace the hot water heater - looks like the stimulus check will come in handy!
-
- Posts: 61152
- Joined: Sun Oct 04, 2015 2:00 pm
- Location: FUCΚ! Even in the future nothing works.
Home Improvement Thread
98? That's one hell of a run, especially if it didn't actually burst.
-
- Posts: 19547
- Joined: Wed Mar 25, 2015 5:02 pm
- Location: Monroeville, PA
Home Improvement Thread
Yeah we replaced ours like 3 weeks after we moved into our new house ha.
Home Improvement Thread
Nope, just started pooling on the top and running down the side onto the floor. We replaced the fittings first, but there was too much rust around the inflow/outflow.98? That's one hell of a run, especially if it didn't actually burst.
Home Improvement Thread
That's rough. Did you have a home warranty?Yeah we replaced ours like 3 weeks after we moved into our new house ha.
-
- Posts: 19547
- Joined: Wed Mar 25, 2015 5:02 pm
- Location: Monroeville, PA
Home Improvement Thread
We did. Ours went like yours did, water coming out the top and down the sides going all over the floor. I ended up getting one from Mr. Waterheater that same day. I called and an hour later they were out removing the old and installing the new with expansion tank. Because of that I had to fight with the warranty company a bit since I didn't call them first.That's rough. Did you have a home warranty?Yeah we replaced ours like 3 weeks after we moved into our new house ha.
Eventually once I explained that I could wait for them to file a claim and go through all of their paperwork since I had water all over my laundry room they refunded what I paid OOP minus the deductible.
Home Improvement Thread
Yeah, that was a good move. My parents needed theirs replaced, and it took 2 weeks through the warranty process. And they didn't really make it happen until after my dad called and Karen'd them.We did. Ours went like yours did, water coming out the top and down the sides going all over the floor. I ended up getting one from Mr. Waterheater that same day. I called and an hour later they were out removing the old and installing the new with expansion tank. Because of that I had to fight with the warranty company a bit since I didn't call them first.That's rough. Did you have a home warranty?Yeah we replaced ours like 3 weeks after we moved into our new house ha.
Eventually once I explained that I could wait for them to file a claim and go through all of their paperwork since I had water all over my laundry room they refunded what I paid OOP minus the deductible.
-
- Posts: 61152
- Joined: Sun Oct 04, 2015 2:00 pm
- Location: FUCΚ! Even in the future nothing works.
Home Improvement Thread
2 weeks? GTFO, that's insane. I had no warranty, but was able to get somebody in either the same day or the next day, I forget which.
Home Improvement Thread
When I had to replace mine in 2019, I used Mr Water Heater also. It's a ridiculous name for a company, but they were there the next day with a very reasonably priced replacement.
-
- Posts: 61152
- Joined: Sun Oct 04, 2015 2:00 pm
- Location: FUCΚ! Even in the future nothing works.
Home Improvement Thread
What brand did they use for you guys? They aren't in my area, and I wanted another Bradford White, if possible. I also needed a power vent model, so a standard WH wouldn't work.
Home Improvement Thread
Mine is a Ruud, but I also left it entirely up to Mr Water Heater. They gave me a few options and recommended this one which ended up being middle of the pack as far as pricing goes. In retrospect, I probably should've done some research but I just wanted to get it done.
-
- Posts: 19547
- Joined: Wed Mar 25, 2015 5:02 pm
- Location: Monroeville, PA
Home Improvement Thread
I just went and looked. Ours is a Bradford White "Defender". I remember we had a few less options because our Hot water tank is literally right next to the furnace on one side and a wall on the other. So they had to install one that was "skinnier" than a normal one, but it's still the same capacity as the old one was. I just went with their recommendation.
Service wise though I called at 8 am, they were at my house by 8:45, and done by 10am that same day. No complaints on service or pricing.
Service wise though I called at 8 am, they were at my house by 8:45, and done by 10am that same day. No complaints on service or pricing.
-
- Posts: 19857
- Joined: Wed Mar 25, 2015 7:33 pm
- Location: Iodine State
Home Improvement Thread
That reminds me: it's been reasonably cold where we are. Getting into the shower, I was nearly scalded a couple of times. I use the same shower handle setting, but the water was really hot. I thought it was just me, until a few days later my wife casually mentioned the same thing.
We have a 12 year old 70 gallon electric water heater (we have a jacuzzi tub, all the rage in 2007 new construction). It's in an insulated but non heated space.
Is the sudden scalding thing the signs of a death knell? It's otherwise heating fine, and the temperature settings are hidden behind two panels - I haven't touched them since we moved in.
I would like to replace it - hopefully eventually - with a heat pump electric water heater. It takes the hot air in the room and uses it to heat water - which is great for us, as it's in a storage room right off our hot garage.
We have a 12 year old 70 gallon electric water heater (we have a jacuzzi tub, all the rage in 2007 new construction). It's in an insulated but non heated space.
Is the sudden scalding thing the signs of a death knell? It's otherwise heating fine, and the temperature settings are hidden behind two panels - I haven't touched them since we moved in.
I would like to replace it - hopefully eventually - with a heat pump electric water heater. It takes the hot air in the room and uses it to heat water - which is great for us, as it's in a storage room right off our hot garage.
-
- Posts: 61152
- Joined: Sun Oct 04, 2015 2:00 pm
- Location: FUCΚ! Even in the future nothing works.
Home Improvement Thread
Do you not have newer valves in your shower? That should handle scalding concerns. Also, what is the temperature of the water heater set to? Mine is probably around 120°, which most recommend to not exceed.
-
- Posts: 61152
- Joined: Sun Oct 04, 2015 2:00 pm
- Location: FUCΚ! Even in the future nothing works.
Home Improvement Thread
My only complaint about the guy who replaced my water heater - and I didn't notice this until many months later - is that they pushed the vent pipe out when they installed it, so if you look down the siding of my house, you can see a bump right where the vent is. I'd have to cut off the PVC and redo the connect at the WH to fix it, and I haven't gotten around to it.Source of the post Service wise though I called at 8 am, they were at my house by 8:45, and done by 10am that same day. No complaints on service or pricing.
-
- Posts: 19857
- Joined: Wed Mar 25, 2015 7:33 pm
- Location: Iodine State
Home Improvement Thread
Yeah, iirc it was set to 110 and bumped it to 120. I forgot that we had a new valve/cartridge installed this fall. Maybe the old one had calcium deposits and was absorbing the initial heat?
-
- Posts: 61152
- Joined: Sun Oct 04, 2015 2:00 pm
- Location: FUCΚ! Even in the future nothing works.
Home Improvement Thread
The easiest way to test, IMO, would be to turn on a tap full hot, and use an instant thermometer to see how hot the water is. If it's over what the WH is set to, there's probably an issue with the thermostat on your WH.
Home Improvement Thread
I need a new water heater as well. What did you guys go with? Mine right now is an electric 50 gallon tank. We now have a natural gas line to our house, so I'm wondering if I should convert to that. Anybody have a tankless? I'm trying to weigh all my options. Upfront cost vs. potential long term savings.
-
- Posts: 12587
- Joined: Sat Mar 28, 2015 3:50 pm
Home Improvement Thread
Looking for some feedback on a plumbing situation since we are kind of talking about plumbing:
there is a cast iron drain pipe with a crack in the basement, but no water is seeping out of it. called a plumber to take a look at it. He saw some damage to the subfloor near the pipe and said he thought there might be other damage to the plumbing stack somehwere behind the walls causing leaks. That being said, the subfloor isn't damp at all, and also keep in mind that this is an old house, so who knows what has gone on over the decade. Not sure if i see any evidence of water damage. Plumber said that he didn't want to replace the cracked pipe without knowing what was going on behind the walls.
For obvious reasons I am not enthused at the idea of tearing up a wall to replace the stack, especially if there is no visible evidence of water damage. Any thoughts? Would a camera insepction of the plumbing stack be a viable option?
there is a cast iron drain pipe with a crack in the basement, but no water is seeping out of it. called a plumber to take a look at it. He saw some damage to the subfloor near the pipe and said he thought there might be other damage to the plumbing stack somehwere behind the walls causing leaks. That being said, the subfloor isn't damp at all, and also keep in mind that this is an old house, so who knows what has gone on over the decade. Not sure if i see any evidence of water damage. Plumber said that he didn't want to replace the cracked pipe without knowing what was going on behind the walls.
For obvious reasons I am not enthused at the idea of tearing up a wall to replace the stack, especially if there is no visible evidence of water damage. Any thoughts? Would a camera insepction of the plumbing stack be a viable option?
-
- Posts: 11619
- Joined: Thu Apr 30, 2015 3:27 pm
Home Improvement Thread
IMO you don't want to mess with a drain pipe. May have to bite the bullet here. Especially since you already see a crack in the basement.Looking for some feedback on a plumbing situation since we are kind of talking about plumbing:
there is a cast iron drain pipe with a crack in the basement, but no water is seeping out of it. called a plumber to take a look at it. He saw some damage to the subfloor near the pipe and said he thought there might be other damage to the plumbing stack somehwere behind the walls causing leaks. That being said, the subfloor isn't damp at all, and also keep in mind that this is an old house, so who knows what has gone on over the decade. Not sure if i see any evidence of water damage. Plumber said that he didn't want to replace the cracked pipe without knowing what was going on behind the walls.
For obvious reasons I am not enthused at the idea of tearing up a wall to replace the stack, especially if there is no visible evidence of water damage. Any thoughts? Would a camera insepction of the plumbing stack be a viable option?
Are you saying there may be another crack in the stack besides the one in the basement?
There's ultrasonic technology to detect small cracks in welds, but not sure if the same could be done on a cast iron pipe. That's the only non-invasive way I could think of. The camera is going to be so grainy it'll be hard to find any cracks. Besides, it's a drain pipe so it most likely has years of deposit built up inside that would cover the crack.
This is confusing too
Wouldn't he have to tear open the walls to replace the pipe anyway?Plumber said that he didn't want to replace the cracked pipe without knowing what was going on behind the walls.
-
- Posts: 61152
- Joined: Sun Oct 04, 2015 2:00 pm
- Location: FUCΚ! Even in the future nothing works.
Home Improvement Thread
I can't imagine that you would be better off with an electric water heater. Unless it was a massive pain or huge cost to run the pipes, I'd be switching to a natural gas water heater.I need a new water heater as well. What did you guys go with? Mine right now is an electric 50 gallon tank. We now have a natural gas line to our house, so I'm wondering if I should convert to that. Anybody have a tankless? I'm trying to weigh all my options. Upfront cost vs. potential long term savings.
-
- Posts: 9330
- Joined: Wed Mar 25, 2015 7:28 pm
- Location: undisclosed
Home Improvement Thread
My 1967 Ruud water heater is still going strong....
-
- Posts: 12587
- Joined: Sat Mar 28, 2015 3:50 pm
Home Improvement Thread
Right now the only visible evidence of a crack is on a visible section of pipe that runs from the kitchen, over top of the washer, then over and behind drywall. The crack is on a jointed piece of cast iron where it comes out from the kitchen and over the to wall. We never really addressed the question of can the jointed piece be replaced because we went from worrying about the cracked piece to talking about tearing out walls very quickly. So I don't really know if the visible crack can be replaced without tearing up the wall.
Wouldn't he have to tear open the walls to replace the pipe anyway?
The only evidence of water damage is a hole in the subfloor, but the hole wasn't moist (twss) and I don't see any evidence of water anywhere else.
Who is online
Users browsing this forum: No registered users and 71 guests