Home Improvement Thread
-
- Posts: 30620
- Joined: Thu Mar 26, 2015 8:53 am
- Location: I have four degrees and am a moron. Don’t let that fool you
Home Improvement Thread
Psht. Doesn’t sound that great
Home Improvement Thread
Also I think there's some sort of limiter on ceiling fans as far as amperege draw?
-
- Posts: 60985
- Joined: Sun Oct 04, 2015 2:00 pm
- Location: FUCΚ! Even in the future nothing works.
Home Improvement Thread
Dafuq? A 150w bulb in that fixture isn't going to overdraw the circuit unless some clown installed 5amp breakers and overloaded it.
-
- Posts: 60985
- Joined: Sun Oct 04, 2015 2:00 pm
- Location: FUCΚ! Even in the future nothing works.
Home Improvement Thread
There's minimal difference between the 100w/120v bulb you just pulled and the 150w/130v bulb you just bought. Maybe 1/10th of an amp.
Home Improvement Thread
It’s actualy 3 tenths of amp.There's minimal difference between the 100w/120v bulb you just pulled and the 150w/130v bulb you just bought. Maybe 1/10th of an amp.
Let’s say he has a 15 amp breaker.
Safe load is 12 Amps. It might not be an issue unless all the other loads with the old bulb already equal that or are close to it. You ideally don’t want to go over the safe load of the breaker. I’ve seen dumbass contractors use 10amp breakers before.
-
- Posts: 7085
- Joined: Wed Mar 25, 2015 6:43 pm
- Location: Those who don't listen will eventually be surrounded by people with nothing to say
Home Improvement Thread
best place to order table pads?
Home Improvement Thread
It's a 15 amp breaker. Also on it are 3 LED ceiling lights and a few outlets that aren't used.It’s actualy 3 tenths of amp.There's minimal difference between the 100w/120v bulb you just pulled and the 150w/130v bulb you just bought. Maybe 1/10th of an amp.
Let’s say he has a 15 amp breaker.
Safe load is 12 Amps. It might not be an issue unless all the other loads with the old bulb already equal that or are close to it. You ideally don’t want to go over the safe load of the breaker. I’ve seen dumbass contractors use 10amp breakers before.
Home Improvement Thread
Then you’re good.It's a 15 amp breaker. Also on it are 3 LED ceiling lights and a few outlets that aren't used.It’s actualy 3 tenths of amp.There's minimal difference between the 100w/120v bulb you just pulled and the 150w/130v bulb you just bought. Maybe 1/10th of an amp.
Let’s say he has a 15 amp breaker.
Safe load is 12 Amps. It might not be an issue unless all the other loads with the old bulb already equal that or are close to it. You ideally don’t want to go over the safe load of the breaker. I’ve seen dumbass contractors use 10amp breakers before.
-
- Posts: 60985
- Joined: Sun Oct 04, 2015 2:00 pm
- Location: FUCΚ! Even in the future nothing works.
Home Improvement Thread
Like I said, you'll be fine.
Home Improvement Thread
"Another life saved." -nobody, probably.
Home Improvement Thread
Like I said before. It is worth looking when increasing amps to see if you’ll be ok. I’ve seen dumbass **** before that could cause damage.
Home Improvement Thread
No. It’s just using common sense. You don’t **** with electricity. I’ve built circuits and wired rooms before."Another life saved." -nobody, probably.
Home Improvement Thread
I power my home with a Tesla coil.
-
- Posts: 15462
- Joined: Fri May 22, 2015 3:13 pm
- Location: dodint is a millennial
Home Improvement Thread
You can test them like you test a 9 volt...I power my home with a Tesla coil.
Home Improvement Thread
What is a table pad?best place to order table pads?
-
- Posts: 6750
- Joined: Wed Mar 25, 2015 7:10 pm
- Location: Less Coronavirus; More Donnie Iris
- Contact:
Home Improvement Thread
It is a layer padding you put on top of table to prevent scratches
-
- Posts: 60985
- Joined: Sun Oct 04, 2015 2:00 pm
- Location: FUCΚ! Even in the future nothing works.
Home Improvement Thread
SDD is on a roll here.
Home Improvement Thread
Anyone know if there is any kind of restriction on adding a wood burning fireplace to an existing home in Westmoreland County? I know some jurisdictions like Wisconsin have effectively made them prohibitive through a combination of legislation and exorbitant insurance rates.
Home Improvement Thread
Ask for forgiveness not permission
(your insurance company would likely want to know)
(your insurance company would likely want to know)
Home Improvement Thread
We're hiring an architect and it will end up being on the plans that get submitted for permit.
The only place I've ever had a functional log burning fireplace was at the beach in NC, go figure.
The only place I've ever had a functional log burning fireplace was at the beach in NC, go figure.
Home Improvement Thread
Is it wrong that I've only got half the basement studded but I already mounted the 65" TV to the wall?
-
- Posts: 9329
- Joined: Wed Mar 25, 2015 7:28 pm
- Location: undisclosed
Home Improvement Thread
Is it wrong that I've only got half the basement studded but I already mounted the 65" TV to the wall?
I don't think so. Priorities...
-
- Posts: 9329
- Joined: Wed Mar 25, 2015 7:28 pm
- Location: undisclosed
Home Improvement Thread
I was up in Erie this afternoon so I stopped at Sherwin Williams to grab a couple gallons. Had to leave empty handed since they were apparently out of Emerald matte base. I wasn't going to paint tonight anyway and they're getting more tomorrow, but really? Seems that shouldn't happen.
Who is online
Users browsing this forum: Lemon Berry Lobster and 157 guests